Campo-equipment BLAZE 800 D/G Manuel d'utilisateur télécharger pdf (Page 10)

CAMPO EQUIPMENT CO. LTD. (ECOBLAZE)

6 Carson Court, Brampton, ON, CANADA, L6T 4P8

Tel: (905) 793-2525 | Fax: (905) 793-8768 | www.campoequipment.com

SEQUENCE OF OPERATION FOR BLAZE 800 D/G

With “Main Switch” in “ON” position and “Controls” in “ON” position and selector on “HEAT”

operation and selector switch in “STAT ON” position and heat stat plugged into receptacle:

1: Heat stat senses a drop in temperature and the ignition control module is energized.

2: The module performs a safe start check and the burner and spark generator start. Burner lights, ignition

stops, and flame current is sensed.

For oil: the Genisys primary control contacts close, the burner motor and ignitor are

energized after a 45 second delay. The primary control energizes the pump solenoid valve and flame is

established. The cad cell senses flame and the burner continues to fire.

3: Temperature controller thermocouple heats up to factory set point (95F) and circulating air blower starts.

4: When the heat stat senses space temperature at set point, the burner shuts down.

5: The circulating blower continues to operate until the air in the unit cools to the factory set point (80F)

then turns off.

With selector switch in “BYPASS” position:

1: The module performs a safe start check and the burner and spark generator start.

2: Burner lights, ignition stops, and flame current is sensed.

3: Temperature controller thermocouple heats up to factory set point (95F) and circulating air blower starts.

4: When the heat/fan selector switch is placed to the off position the burner shuts down.

5: The circulating blower continues to operate until the air in the unit cools to the factory set point (80F)

then turns off.

OPERATING INSTRUCTIONS FOR BLAZE 800 D/G

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Pas de commentaire

Campo-equipment BLAZE 800 D/G Manuel d'utilisateur Page 10